Workshop tinkering, ordering and an impressive post idea
Posted By RichC on August 26, 2023
Since I now have a few more featherboards to use with my table saw and router table, it seemed like a good idea to add a couple T-Tracks. Most modern woodworking workshops now seem to use these anodized aluminum tracks for a variety of purposes … they will be helpful for hold downs on my small sleds too. I realized the short ones on my drill press table are “the wrong size” to fit my new clamp gadgets, so decided to buy a couple low-cost 400mm ones online and make a couple of my own setups. Nothing pressing at the moment, but I’m looking forward to tinkering with them.
I also saw this fence post idea and thought it was interesting .. although personally haven’t had all that much problem with pressure treated posts … other than gate posts and the underground rot.
Comments