RichC | September 15, 2024
The summer growing season is over and I’m eating the last of the tomatoes that KDAE brought from NW Ohio. They were a real treat and “all for me” since I’m the only one in the family who loves and eats tomatoes. They were so much better than store bought. Also, I know I sort […]
RichC | March 8, 2022
The final steps of finishing the rocking chair for my granddaughter are finally getting done. The canvas strips of material have been added with a little flexible adhesive in the center and epoxy on the ends. The canvas material should do a couple things, first prevent the painted rockers from wearing to bare wood and […]
RichC | January 20, 2021
It is common when woodworking on a bench to use some kind of vise or clamp to hold down a work piece. For longer boards I’ve always used either a couple of clamps on each end or my home-built vise and square hardwood bench dogs. (below) BUT … I’ve envied woodworkers who have 3/4” holes […]
RichC | November 11, 2020
Tweak by tweak I’m staring to enjoy working on my dad’s Packard Hawk. For the past five years I’ve been unmotivated or shy about calling the car that was my dad’s and before that his uncle’s, mine, … but as the list of non-working repairs and fixes grows, I’m seeing a path to making it […]
RichC | April 23, 2020
After cutting a few miter joints earlier this month with a 45 degree jig on my table saw crosscut sled, I started to contemplate the best way to cut clean tendons and dadoes. In the past I’ve used an added fence to the stock miter gauge, but it really doesn’t do a great job. Of […]
RichC | February 4, 2020
This content is restricted.
RichC | January 23, 2020
It has taken years, but I’ve finally decided to move my woodworking bench dogs from the tool tray (see below). A bench dog is an accessory used on a woodworking workbench to allow clamping of wooden items while being worked or planed. Ever since building my work table and vices with bench dogs back in […]
RichC | November 17, 2019
When it comes to clamping, I ascribe to the rule of thumb that you can never have too many clamps when woodworking. That said, I often don’t have enough when I’m working on a project … and lately it has been even worse since a few of my tools are in Florida (Condo1718 projects). Currently […]
RichC | January 31, 2019
In my workshop there is a spot on the wall behind dad’s small drill press and my router table for old tools. As mentioned before, I use Brenda’s dads’ dental tools regularly and have put a few of DadH’s woodworking tools on the wall – it is too bad I passed on the dental chair. […]
RichC | January 27, 2019
After finally removing my built-in radial arm saw from my workbench, I was able to rework the area attached to my workbench in order to fit my “somewhat new” 12” Hitachi Miter Saw. With this new sliding miter saw, I no longer have a need for bulky power tool duplication, and as a workshop accumulates […]
RichC | December 20, 2017
Just in case there are a few men looking for last minute jewelry gifts to give to their sweetheart for Christmas, here’s a ring idea that will pretty much guarantee that you’ll never need to worry again – you’ll either be alone … or dead! And since I know there is sure to be a […]